Monthly Archives: June 2015

Caution to Contractors: Bending Techniques for Aluminum Differ from Steel

When metal roofing manufacturers first introduced aluminum material for standing seam roofing, much of the aluminum produced was .032 thickness.

However, over the years the building products industry has been gravitating to thicker roofing and trim material, especially in aluminum. And, Dade County Florida enacted new wind uplift rules for metal roofing that required the use of .040 aluminum for roofs and .050 thickness for trim material to meet the rule requirements.

Consequently, contractors were transitioning from the use of .018 to .024 thick Galvalume or Hot Dipped Galvanized steel roofing and trim products to .032 to .050 thick Aluminum. Many contractors assumed aluminum bent the same as steel and therefore thought little adjustment was needed to make crisp bends on aluminum as they had done with steel. This resulted in some contractors bending these heavier aluminum products beyond their tensile strength limits resulting in cracking of the metal and paint as well as leaving a silver look from the crazed aluminum under the paint. Continue reading

Compelling Data that Supports Metal Roofs Offer Longer Service Life

New industry research shows that metal roof systems can last at least 60 years, longer than the average commercial building’s service life.

“The study provides third-party, scientific data that backs up the long held belief that 55% aluminum zinc coated steel standing seam roofing systems offer economic longevity and can be better for the environment.

Non-metal roofing systems require one or more full replacements within a typical commercial building’s 60-year service life, which is more expensive over the long run and usually adds to the solid waste stream in landfills.Metal roofin gon the Wilkes Barre Terminal

The study, sponsored by the Metal Construction Association and the Zinc Aluminum Coaters Association, was conducted with oversight of three independent consulting firms which analyzed low-slope, unpainted 55% Aluminum-Zinc coated steel standing seam roofing, in a wide range of environments across the U.S.

The material tested is commercially known as Galvalume and Zincalume and is commonly used on low rise commercial buildings such as warehouses, schools, distribution centers, shopping centers, government structures, sports and exposition facilities and other structures. Continue reading

Free Englert Roofing Mobile App Download:

Easy access to all Englert brochures and catalogs, a color selector for both roofing and gutter colors, standing seam metal roof panel profiles, and a convenient coil calculator to assist in estimating and completing your particular project.

Copyright 2018 - Englert Inc. - All rights reserved - Designed and Developed - Sitemap - Terms & Privacy